Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
58917B
1.REMOVE BOX BOTTOM MAT
Remove the box bottom mat.
55474B
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using moulding remover B, detach the 2 clips and remove the instrument cluster finish panel garnish.
55084E
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Remove the 3 screws <A> and No. 1 heater to register duct sub-assembly.
55085
4.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Remove the 2 screws <A> and No. 2 heater to register duct sub-assembly.
55660
5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Use the same procedure to remove the No. 2 instrument panel register assembly on the other side.
Detach the 3 claws and remove the No. 2 instrument panel register assembly.
82142
6.REMOVE NO. 2 INSTRUMENT PANEL WIRE (w/ Speaker)
Detach the 8 wire harness clamps and remove the No. 2 instrument panel wire.
86860
7.REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
55833C
8.REMOVE CENTER INSTRUMENT PANEL REGISTER CONNECTOR
Remove the 2 screws <A> and center instrument panel register connector.
82142A
9.REMOVE NO. 2 INSTRUMENT PANEL WIRE
for Single Type Airbag:
for Dual Type Airbag:
73960A
10.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
for Single Type Airbag:
for Dual Type Airbag:
55355
11.REMOVE NO. 1 INSTRUMENT PANEL CUSHION
Remove the 2 No. 1 instrument panel cushions.
55358K
12.REMOVE NO. 4 INSTRUMENT PANEL CUSHION
Remove the No. 4 instrument panel cushion.
13.REMOVE GLOVE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)

| *1 | Stopper |
Push the stopper to release the lock, and then push the glove compartment door lock cylinder assembly and remove it from the glove compartment door assembly.